68RFE Transmission Rebuild Kit Category 0 For Dodge Cummins SC-68-0
Part Number: SC-68-0
Kit Includes the Following:
- New 68RFE Thrust Washer Kit
- New 68RFE Thrust Bearing Kit
- 68RFE Complete Gasket and Sealing Kit
- 68RFE Spin-on Filter
- 68RFE Pan Filter
- 68RFE Underdrive and Overdrive piston set
- Upgraded 2C Clutch Set
- 68RFE Billet 2C Piston
The "RFE" stands for Rear-wheel drive Fully Electronic control. The RFE design was mostly noted in the new design to have 3 planetary sets for a 4-speed transmission in the 45RFE.
In 2007, Chrysler debuted the new 6.7 Powerplant in the all new Dodge Ram, and Dodge wanted a transmission that was specifically designed for function. The previous platform utilized the Torqueflite 48RE platform and had been around since the late 50's when they released the first 727 in 1956 after purchasing the license from Simpson on the gearset in 1955.
The 46/47/48 Chrysler platforms were 3 and 4-speed units that were mechanically and hydraulically controlled, with the most notable control system being governor pressure.
The first improvement Chrysler wanted to make over the Torqueflite platform was, obviously, the amount of forward gear. For the 68RFE transmission, Chrysler opted to change to a six-speed unit. The additional gears allowed Chrysler to add higher 1st-gear ratios and tighter shift recovery from one gear to the next. The tighter shift recovery essentially keeps the vehicle in higher averaged horsepower and torque numbers, while also adding torque multiplication.
The gear ratios were increased. as well. The new 68RFE boasts a whopping 3.23:1 first gear, compared to the 2.45:1 first gear found in the previous 47/48RE platform. Chrysler also increased second gear to a 1.83:1 versus the 1.45:1 found previously. The 68RFE was also given two overdrive gears, with 5th being .81:1 and 6th with the very deep .62:1. The predecessor had a single overdrive that was a .69:1.
The Category Kits
The SunCoast Category 68RFE transmission rebuild kits are designed and developed with intentions of taking a systematic approach to solving the issues with the 68RFE transmission. We approach each deficiency and need from a scientific approach.
These kits offer you the same recipes that are used in our facility. We aim to offer you the most complete series of 68RFE rebuild kits available on the market today.
The 2C Piston
The factory molded piston is prone to uneven apply, which leads to excessive heat in the clutches and steels creating premature failure. In this 68RFE transmission rebuild kit we replace the factory piston with a much-improved billet piece that also allows for one additional clutch, further increasing surface apply area.
These new 68RFE transmission rebuild kits are designed with the builder in mind, and we offer from mild to wild depending on what your needs are.
The Clutch Pack
Dodge trucks pulling heavy loads or boosted to 400-600HP are at high risk for overdrive burn-up due to the stock transmission's insufficient clutch capacity and fragile OE clutches. Even small amounts of heat and extra torque will push the thin (.034"), single-sided clutches over the edge, distorting the clutch pack. The fact is, any distortion of the clutch pack takes the clearance out of spec and makes overdrive clutch burn-up inevitable.
Keep hardworking trucks on the road with the Sonnax Smart-Tech® overdrive clutch housing kit 72960-06K. The unique billet aluminum housing holds a physically taller clutch pack and increases OD apply area by 16%. Plus, 2X thicker clutches increase clutch pack steel mass by 28% for unrivaled heat dissipation. This groundbreaking new kit is the only top-of-the-line upgrade that eliminates clutch problems without relying on valve body/pump modifications or adding the expense of extra components.
- Modified housing holds physically larger clutch pack for 20% more clutch capacity
- 2x-thicker steels and double-sided clutches increase steel mass by 28% for unrivaled heat dissipation
- Bolt-on anchor plate eliminates clutch pack flexing and distortion that contribute to heat build-up
- 16% more OD apply area for firmer, more controlled shifts
- Combine with Sonnax line pressure booster kit RFE-LB1 for even higher levels of performance
- 2018 Ram 2500
- 2018 Ram 3500
- 2017 Ram 2500
- 2017 Ram 3500
- 2016 Ram 2500
- 2016 Ram 3500
- 2015 Ram 2500
- 2015 Ram 3500
- 2014 Ram 2500
- 2014 Ram 3500
- 2013 Ram 2500
- 2013 Ram 3500
- 2012 Ram 2500
- 2012 Ram 3500
- 2011 Ram 2500
- 2011 Ram 3500
- 2010 Dodge Ram 2500
- 2010 Dodge Ram 3500
- 2009 Dodge Ram 2500
- 2009 Dodge Ram 3500
- 2008 Dodge Ram 2500
- 2008 Dodge Ram 3500